Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
cnc:froehliche_wissenschaft [2019/01/03 18:36] admin |
cnc:froehliche_wissenschaft [2020/02/14 17:00] (current) admin [Die Fröhliche Wissenschaft] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Froehliche | + | ===== Die Fröhliche |
{{: | {{: | ||
- | A CNC controll system for the installation | + | |
- | It's based on a Raspberry Pi that controls | + | The installation [[http:// |
+ | |||
+ | It' | ||
+ | |||
+ | The controlling system is based on a Python program that runs on a Raspberry Pi that controls | ||
+ | An other Arduino is for the chalk control. The chalk control is activated with a Reed Relais.\\ | ||
+ | |||
+ | All controlling systems, the hard - and software was designed and made by Wolfgang Spahn 2014.\\ | ||
---- | ---- | ||
==== Software ==== | ==== Software ==== | ||
+ | |||
+ | Here is the code for a CNC control system of the installation: | ||
* {{ : | * {{ : | ||
* {{ : | * {{ : | ||
Line 14: | Line 23: | ||
{{: | {{: | ||
+ | |||
+ | ==== Hardware ==== | ||
+ | |||
+ | The controlling is done with:\\ | ||
+ | * a [[https:// | ||
+ | * an [[https:// | ||
+ | and the following Paper Boards:\\ | ||
+ | * a [[https:// | ||
+ | * three [[https:// | ||
+ | * two [[https:// | ||
+ | |||
+ | |||
+ | ---- | ||
+ | ==== License ==== | ||
+ | |||
+ | The Paper Duino Pim the Motor Control Board and the Stepper-Motor-Board are designed by **Wolfgang Spahn** 2012-14\\ | ||
+ | \\ | ||
+ | All programs are written by **Wolfgang Spahn** 2014.\\ | ||
+ | \\ | ||
+ | They are licensed under a [[http:// | ||
+ | |||
+ | < | ||
+ | <a rel=" | ||
+ | </ | ||
+ | |||
---- | ---- |