Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
linux:oscilloscope [2020/11/16 20:35] admin [MICoscope] |
linux:oscilloscope [2020/11/16 21:19] admin [Oscilloscope for Linux] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Oscilloscope for Linux ====== | ====== Oscilloscope for Linux ====== | ||
+ | {{: | ||
+ | A simple and easy USB soundcard hack for an Oscilloscope. The best use is together with an bread board.\\ | ||
+ | But please be careful, no protection is build in. Input signals up to 5V should be save.\\ | ||
---- | ---- | ||
===== Software ===== | ===== Software ===== | ||
==== XOscope ==== | ==== XOscope ==== | ||
+ | {{: | ||
+ | |||
Download xoscope-2.2.tar.gz from:\\ | Download xoscope-2.2.tar.gz from:\\ | ||
[[https:// | [[https:// | ||
Line 22: | Line 27: | ||
[[https:// | [[https:// | ||
Unpack it and run it: | Unpack it and run it: | ||
- | $ tar -xvf micoscope-linux-1.0.tar.gz | + | $ tar -xvf micoscope-linux-1.0.tar.gz |
- | $ $ cd micoscope-linux-1.0/ | + | |
- | $ ./MicOscope | + | |
---- | ---- | ||
===== Hardware ===== | ===== Hardware ===== | ||
- | Use a cheap USB Soundcard.\\ | + | {{: |
- | Or build a protection circuit | + | {{: |
- | [[http:// | + | Use a cheap USB soundcard. Open the housing and solder a wire to the ground and the signal pin.\\ |
- | One can use a 1N4148 | + | {{: |
+ | Close the housing, that's i!\\ | ||
+ | |||
+ | Best use is together with a breadboard | ||
+ | For an simple input protection a decoupling capacitor and a potentiometer to attenuate the signal would be useful, too.\\ | ||
+ | Poti | ||
+ | | ||
+ | | | ||
+ | |____Mic Input | ||
+ | |||
+ | If you want build a better | ||
+ | [[http:// | ||
+ | One can use 1N4148 | ||
---- | ---- |